Startup Of The Product; Intended Use; Priming The Product - Grundfos JP Serie Instrucciones De Instalación Y Funcionamiento

5. Startup of the product

WARNING
Electric shock
Death or serious personal injury
‐
Do not use the product for cleaning and other
maintenance of swimming pools or similar places if
there are people in the water.
CAUTION
Hot surface
Minor or moderate personal injury
‐
Use protective gloves if the liquid or ambient
temperature is higher than 104 °F (40 °C).
CAUTION
Hot surface
Minor or moderate personal injury
‐
Do not run the pump continuously with a closed inlet or
outlet valve.
CAUTION
Hot or cold liquid
Minor or moderate personal injury
‐
Make sure that escaping hot or cold liquid does not
cause injury to persons or damage to the equipment.
Do not turn on the power supply until the pump has been
filled with liquid.
The number of starts and stops must not exceed 20 times
per hour.
The pump must not run without delivering water for more
than 5 minutes.
Only use the product for the intended use and for the
pumped liquids stated in these installation and operating
instructions.
Related information
4.3.3 Setting the voltage converter
5.1 Priming the product
6.1.1 Intended use
6.2 Pumped liquids

5.1 Priming the product

Always tighten the priming plug by hand.
1. Unscrew the priming plug.
2. Fill the pump with water.
3. Refit the priming plug and tighten by hand.
1
2
3
Priming the JP PS pump
Related information
5. Startup of the product
15