Rotary 100 Serie Instrucciones De Instalación página 7

STANDARD
Minimum Floor
Thickness
Anchor
Minimum Concrete
Strength
Minimum Anchor
Embedment
Minimum Distance
to Concrete Edge,
Crack, Expansion Joint,
Abandanoned Anchor
Hole
*The supplied concrete fasteners meet the criteria of the American National Standard
"Automotive Lifts - Safety Requirements for Construction, Testing, and Validation" ANSI/ALI ALCTV-2011, and the lift
owner is responsible for all charges related to any additional anchoring requirements as specified by local codes.
Drill holes using 5/8" carbide
tipped masonry drill bit per
ANSI B212.15-1994 (R2000).
Construction dust collected
per OSHA 29 CFR 1926.1153.
CONCRETE AND ANCHORING REQUIREMENTS
ANSI/ALI ALCTV
4-1/4 INCHES 4-3/8 INCHES
(108mm)
Hilti Kwik Bolt III* Hilti HIT-HY
5/8" x 4-1/4" 150MAX-SD
Adhesive; Hilti
HIT-HY 150 MAX
Adhesive; HILTI
HIT-RE 500-SD
Adhesive
3000 PSI
(20684 kPa)
2-3/4 INCHES 3-1/8 INCHES
(70mm)
4-1/2 INCHES 3-1/8 INCHES
(114mm)
Contact customer service for further information at: 800.445.5438
Run nut down just below impact
section of bolt. Drive anchor
into hole until nut and washer
contact base.
IBC 2006, 2009, 2012
5 INCHES
(111mm) (127mm)
Hilti Kwik Bolt III
5/8" x 6"
3000 PSI 3000 PSI
(20684 kPa) (20684 kPa)
3-1/8 INCHES
(79mm) (79mm)
2-1/4 INCHES
(79mm) (57mm)
7
Tighten nut with Torque
wrench to 60 ft.-lbs
.
(81 Nm).
Fig. 12a
SEISMIC
Varies by location consult
with your structural
engineer and manufacturer's
representative.
Fig. 12b