Abicor Binzel iSTM Instructivo De Servicio página 39

iSTM
9.3 Cleaning the iSTM ABIROB
1
Retaining ring
1
Lock ring
2
Cleaning the iSTM ABIROB
Fig. 13
9.4 Cleaning the wire liner
®
GC
2
O-ring 54x2
3
®
GC
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in
particular safety goggles.
1 Clean the iSTM ABIROB
2 Remove retaining ring (1) and lock ring (2).
3 Check the O-ring (3) for wear and replace it if necessary. Before replacing,
grease the O-rings (3) with sealing grease (included in the scope of
delivery).
4 Mount lock ring (2) and retaining ring (1).
 Fig. 10 Mounting the wire liner on page EN-15
1 Check with maintenance and cleaning intervals the o-ring (6) for wear and
replace it if necessary.
9 Maintenance and cleaning
3
iSTM ABIROB
4
®
GC (3) with compressed air.
4
®
GC
EN - 19