GreenWorks 27017 Manual De Utilización página 22

EN
FR DE ES IT PT
NOTE: The unit will not operate properly if the tines are
installed incorrectly. If you notice a problem with the
cultivating operation of the unit, check for proper tine
positioning.
TINES INSTALLED CORRECTLY
NOTE: When the tines are installed correctly, the flute
on the tines should line-up, and the angled edge of the
tine blades should point towards the ground.
NOTE: The tiller will not operate properly if the tines
are not installed correctly. If there is a problem with the
cultivating operation of the tiller, check the tines for
proper positioning.
NOTE: The directional arrow that is displayed on each
tine should point toward the front.
INSTALLING TWO TINES FOR
TILLING A NARROW AREA
Place tine (A) onto the shaft, and place tine (D)
onto the other side shaft. Insert the hitch pin into
the holes in order to secure the tines to the tine
shaft.
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
s e c o n d s i s f u c i f e i t n o t n i
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
WARNING:
Do not allow hands, feet, or any other part of
the body or clothing near the rotating tines or
any other moving part. The tines begin to rotate
forward once the switch trigger is depressed. The
tines continue to rotate until the switch trigger is
released. Failure to avoid contact could cause
serious personal injury.
STARTING THE CULTIVATOR
NL SV DA NO FI HU CS RU
English(Original Instruction)
STOPPING THE TILLER/CULTIVATOR
Release bale switch to stop the cultivator.
l f t c i s r e o i u s j n i r u . y
18
RO PL SL HR ET
Plug the cultivator into an approved outdoor
extension cord.
Press the Safety-lock out button and pull
the Bale Switch upwards to the handle
bar to begin the rotation. Release Safety
lock-out button while continuing to hold
upward on Bale Switch to continue use.
PREPARING THE SEED BED
The cultivator can be used to break up garden
soil and prepare a seedbed for planting. Plan
ahead to leave enough room between the
seed rows to allow for machine cultivating after
the plants have grown.
TILLING SOD:
Tilling sod into the soil is not recommended. If
sod must be removed to perform application
then it is suggested to do as follows:
Map out the area of sod required to be
removed.
Lift the sod from the edges using a shovel
sliding below at the roots.
Remove the sod. Carry sod to compost or
other pile turned grass down to allow grass
to decompose.
Once sod layer is removed, begin to till the
soil to desired depth.
LT LV SK BG