Harbor Breeze E-TLE44BNK5C1 Manual Del Usuario página 10

FINAL INSTALLATION
2.
Align the preassembled blade screw posts (J) on
blade arms preassembled to motor housing (D) with
the holes on a blade (G).
Press up on the blade arm firmly so the blade screw
posts (J) come through the holes in the blade (G),
then slide a three-C clip (BB) onto each blade
screw post (J).
Repeat for each blade arm and blade (G).
WARNING: To reduce the risk of personal
injury, make sure the friction detents on three-C clip
(BB) face down and recessed groove faces up.
Slide three-C clips (BB) completely under blade
screw posts (J) so edges of blade screw posts (J)
are captured by the recessed groove on the three-C
clips (BB).
Hardware Used
BB
Three-C clip
NOTE: To install the fan without the light kit, proceed to INSTALLING FAN WITHOUT LIGHT KIT on
page 12.
If you wish to use the fan WITH the light kit,
3.
remove finial (O), finial plate (I), rubber washer (Q)
and hex nut (K) from the threaded rod at the bottom
of the light kit fitter (F). Save hardware for later use.
2
x 3
3
Threaded
Rod
10
J
Recessed
Groove
X
J
Q
K
O
Lowes.com/harborbreeze
BB
Friction
Detents
BB
G
F
I