Dustbin Full; Bag Replacement Switch Activated; Alarms - Nederman FlexVAC Manual De Usuario

6.2.1 Dustbin Full
The Bin Level Indicator has detected that the dust bin has been full for 12 minutes.
• Empty the dust bin and press 'OK' to reset the warning.
Warning!
D u s t b i n F u l l
Th 15:01
Time To Unit
Stop 05:00 m
Reset OK Æ
6.2.2 Bag Replacement Switch Activated
The bag replacement switch (SC2) is activated. It shows the maximum allowed time to replace the dust bag, and
how much time is left to replace the dust bag and turn off the bag replacement switch before the unit is put into
Off mode.
If this warning is activated, the light in the Standby/Running button is lit for two seconds and then again in 2
seconds. This 2/2 on/off sequence continues until the warning is reset.
Bag Replacement
Switch Activated
Time to Unit
Stop 02:00m
Max Time 30:00m
6.3 Alarms
If an alarm is activated, the unit goes into Off mode until the problem is corrected.
If an alarm message is displayed in the PLC display, the light in the Standby/Running button flashes one second
on, one second off. This 1/1 on/off sequence continues until the problem is corrected and the alarm reset. See
also the PLC Settings Manual and the Installation and Service Manual.
FlexVAC
Clean: Remaining time for cleaning pulse.
Charge: Remaining vacuum build time. The time un-
til the cleaning pulse is activated. Charge = Vacuum
building time (Charge time).
Pulse: How many cleaning pulses are made of 3.
ESC OK
Stop: The remaining time to replace the dust bag be-
fore the unit is put into Off mode.
MaxTime: The maximum amount of time allowed to
replace the dust bag.
ESC OK
EN
21