Time For Service; Main Filter Clogged; Dustbin Full; Bag Replacement Switch Activated - Nederman FlexPAK 800 Manual Del Usuario

All manuals and user guides at all-guides.com
button flashes one second on, one second off. This 1/1 on/off sequence continues until the problem
is corrected.
NOTE!
There are two exceptions to this rule, Sections '10.3.1 Time For service' and

'6.3.4 Bag Replacement Switch Activated'.

6.3.1

Time For service

The time interval set in the 'Service Interval Setting' menu has expired. If this warning is
activated, the light in the Standby/Running button is lit one second and then again in 7 seconds.
This 1/7 on/off sequence continues until the warning is reset.
Reset the alarm by first putting the unit into Standby mode. In Standby mode, press the manual
filter cleaning button for 10 seconds.
Time for
Service
Reset OK ==>
NOTE!
For a description of the following displays please see the 'Installation and service
manual'.
6.3.2

Main Filter Clogged

Main
Filter Clogged
Reset OK ==>
6.3.3

Dustbin Full

Dustbin
Full
Reset OK ==>
6.3.4 Bag Replacement Switch Activated
Bag Replacement Switch
Activated
MaxTime 30:00m
RemTime 28:14m
6.4

Alarms

If an alarm is activated, the unit goes into Off mode until the problem is corrected.
If an alarm message is displayed in the PLC display, the light in the Standby/Running button
flashes one second on, one second off. This 1/1 on/off sequence continues until the problem is
corrected and the alarm reset.
The following is a list of alarm messages can be read on the PLC display:
•
External Fire Alarm Explosion Detected
•
Frequency Conv Alarm
•
PTC Detect Hi Motor Temp Unit Shut Down
•
Low Pressure
ESC OK
ESC OK
ESC OK
ESC OK
FlexPAK 800/1000 DX EN
35