Filter Cleaning; Warning Messages; Dustbin Full; Bag Replacement Switch Activated - Nederman FlexPAK 800 Manual De Instrucciones

EN FlexPAK 800/1000 DX
6.1.5

Filter Cleaning

The unit is cleaning its main filter.
Filter
Cleanining
Cycles 1
Elapsed 0
Clean 00:00 s
Charge 00:00 s
6.2

Warning messages

If a warning is activated, there is a problem that needs to be corrected, but the unit
continues to work. If a warning message is displayed in the PLC display, the light in the
Standby/Running button flashes one second on, one second off. This 1/1 on/off sequence
continues until the problem is corrected. See also the PLC Settings Manual and the
Installation and Service Manual.
NOTE! There are two exceptions to this rule, Sections '10.3.1 Time For service' and

'6.2.2 Bag Replacement Switch Activated'.

6.2.1

Dustbin Full

The Bin Level Indicator has detected that the dust bin has been full for 12 minutes. Empty
the dust bin and press
Warning!
D u s t b i n F u l l
Th 15:01
Time To Unit
Stop 05:00 m
Reset OK 
6.2.2 Bag Replacement Switch Activated
The bag replacement switch (SC2) is activated. It shows the maximum allowed time to
replace the dust bag, and how much time is left to replace the dust bag and turn off the
bag replacement switch before the unit is put into Off mode.
If this warning is activated, the light in the Standby/Running button is lit for two seconds
and then again in 2 seconds. This 2/2 on/off sequence continues until the warning is reset.
Bag Replacement
Switch Activated
Time to Unit
Stop 02:00m
Max Time 30:00m
6.3

Alarms

If an alarm is activated, the unit goes into Off mode until the problem is corrected.
If an alarm message is displayed in the PLC display, the light in the Standby/Running
button flashes one second on, one second off. This 1/1 on/off sequence continues until
the problem is corrected and the alarm reset. See also the PLC Settings Manual and the
Installation and Service Manual.
28
Cycles: How many cleaning pulses will be carried out.
Elapsed: How many cleaning pulses are made.
Clean: Remaining time for cleaning pulse.
Charge: Remaining vacuum build time; the time until cleaning pulse is
activated.
ESC OK
to reset the warning.
OK
Clean: Remaining time for cleaning pulse.
Charge: Remaining vacuum build time. The time until the cleaning pulse
is activated. Charge = Vacuum building time (Charge time).
Pulse: How many cleaning pulses are made of 3.
ESC OK
Stop: The remaining time to replace the dust bag before the unit is put
into Off mode.
MaxTime: The maximum amount of time allowed to replace the dust
bag.
ESC OK