Running (Running Mode); Flexpak Idling (Idling Mode); Filter Cleaning; Warning Messages - Nederman FlexVAC Manual De Usuario

6.1.3 Running (Running mode)
EN
The unit is in Running mode. The pump motor is on and the unit generates a vacuum. The FCV is closed. The cur-
rent vacuum of the unit is shown on the display, for example, -20 kPa.
Running
kPA
DIRTm
OTTmr
Exhaust
Air Temp
6.1.4 FlexPAK Idling (Idling mode)
The unit is in Idling mode. The pump motor is on, there is no vacuum, and the FCV is open. The unit goes into
Idling mode when there has been no pilot signal for the time set in DIR_Time.
FlexPak
Hi Vacuum Unit
IDLING
Time To StandBy
05:33m
6.1.5 Filter Cleaning
The unit is cleaning its main filter.
Filter
Cleanining
Cycles
Elapsed
Clean
Charge
6.2 Warning messages
If a warning is activated, there is a problem that needs to be corrected, but the unit continues to work. If a warn-
ing message is displayed in the PLC display, the light in the Standby/Running button flashes one second on, one
second off. This 1/1 on/off sequence continues until the problem is corrected. See also the PLC Settings Manual
and the Installation and Service Manual.
There are two exceptions to this rule, Section '3.2.1 Time For service' in the PLC Settings Manual and
tion 6.2.2 Bag Replacement Switch Activated
20
-20
00:00 s
00:00 h
60°C
ESC
ESC
1
0
00:00 s
00:00 s
ESC
FlexVAC
DIRTm: The amount of time before the unit goes into
Idling mode. The default is 10 seconds.
OTTmr: If the Overtime timer has been activated,
OTTmr shows the elapsed time since the overtime
timer started.
OK
TimeToStandby: The amount of time until the unit
goes into Standby mode. The default setting is 12
minutes.
OK
Cycles: How many cleaning pulses will be carried out.
Elapsed: How many cleaning pulses are made.
Clean: Remaining time for cleaning pulse.
Charge: Remaining vacuum build time; the time until
cleaning pulse is activated.
OK
in this manual.
Sec-