Iso Ddin Radio Provision; Aswc-1 Programming - Metra 99-5827B Instrucciones De Instalación

ISO DDIN radio provision

1. Mount the factory display to the radio
housing brackets with the supplied
carriage bolts and Keps nuts. (Figure A)
2. Slide the radio into the radio bracket
assembly and secure with screws
supplied with the radio. (Figure B)
3. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
4. Mount the assembly into the sub dash.
5. Reassemble the dash in the reverse
order of disassembly using the
99-5827B trim panel instead of the
factory panel.
KIT ASSEMBLY
(Figure A)
Detail
Note: The integrated buttons on this kit
are used to navigate the factory display
above the radio. The button below the
info button can be used to turn the
factory screen on and off if desired.
The remainder of the control functions
are the same as factory was prior to
aftermarket installation.
C ontinue to ASWC-1 programming
(Figure B)
REV. 11/13/2017 INST99-5827B
5