Dynamic Alignment - Össur PRO-FLEX LP TORSION Instrucciones De Uso

The protective film on the pyramid must be removed when device fitting
is complete.
NB: The device is designed to be used with a Spectra sock, and
recommended foot cover. The device should not be used without these
accessories.
WEATHERPROOF
A weatherproof device allows use in a wet and/or humid environment,
but does not allow submersion. Fresh water splashing against the
enclosure from any direction shall have no harmful effect. Dry thoroughly
after contact with fresh water. Fresh water: Includes tap water. Excludes
salt and chlorinated water.
For a weatherproof system, weatherproof components must be selected
for use with the device.
BENCH ALIGNMENT (Figure 3)
• Fit foot with selected cover and shoe.
• Adjust to appropriate heel height (using the shoe).
• Ensure appropriate angles (flexion/extension and abduction/
adduction).
• Divide the foot cover into 3 equal portions.
• The load line should fall at the junction of the posterior and the
middle third portions as shown in figure 3.
• The 1/3 position is marked on the inside wall of the foot cover.

DYNAMIC ALIGNMENT

The heel stores energy after initial contact, slowly releasing it at mid-
stance. The forward momentum generated by this action results in the
toe being loaded for optimum energy release at terminal stance.
The heel-to-toe action can be influenced by:
• Anterior/posterior positioning of the foot
• Dorsi-plantarflexion
• Heel stiffness
HEEL STIFFNESS
Heel too soft
Symptoms
• Foot comes to a flat position too early (user feels they are sinking into
a hole).
• Extra energy required to climb up over the toe.
• Toe feels too stiff.
• Knee may hyperextend.
Actions
• Shift socket anterior (or foot posterior).
Heel too hard
Symptoms
• Rapid heel-to-toe movement.
• At initial contact the user has poor control of prosthesis.
• User feels minimal energy return.
• Knee may become unstable.
7