High Pressure; Low Pressure - Power Stroke PS80516A Manual Del Operador

SELECTING THE RIGHT NOZZLE FOR THE
JOB
See Figure 16.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more informa-
tion about which nozzle to choose.
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and NEVER point the wand at your
face or at others. The quick-connect feature contains
small springs that could eject the nozzle with some force.
Failure to heed this warning could cause personal injury.
Using the quick-connect collar, changing nozzles is easy.
To connect a nozzle to the trigger handle:
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
ABRASIVE
Concrete, Brick, masonry
siding, gutters, House
fencing, Deck, Patio
lawn equipment, Boat, rv
OPERATION
NOZZLE SELECTION GUIDE

HIgH Pressure

25º green
GENTLE





recommended nozzle
Page 12 — English
 Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.
 Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Pull back and hold the quick-connect collar.
 Remove the nozzle by pulling it from the quick-connect
collar. Place nozzle in the nozzle storage area on the top
of the machine.
(no soaP)
40º white





use with caution for certain applications

low Pressure

(for soaP or
gentle rInse)
Blue soap nozzle



