Kyocera DU-31 Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Duplex Printing Mode Settings
Settings for the duplex printing mode are made on the printer's control panel.
Settings on the Printer's Control Panel
Make the settings for duplex printing and binding on the printer's control panel
using the following procedure.
1.
Confirm that Ready is indicated on the printer's message display and
that the on-line indicator is lit.
2.
Press the printer's MODE key.
3.
Display "paper handling >
key to display " > Duplex mode". The second line indicates the
current mode. (In the initial state, None is shown.) In the case of an FS-
7000, using the + or – key, display Duplex mode on the message
display.
4.
When the ENTER key is pressed, the ? mark flashes and the display can
be changed by pressing the + or – key as shown in the following diagram.
Duplex mode
?None
Duplex mode
?Short edge bind
Duplex mode
?Long edge bind
To abandon the setting, press the CANCEL key.
5.
Select the desired binding mode and press the ENTER key.
6.
When the MODE key is pressed, the message display indication returns to
Ready.
The same setting can also be performed by accessing the printer driver from the
printer setting menu of your appplication software.
12
press the
key, and press the + or –
",
Duplex printing is not performed.
(Initial setting)
Short edge binding
Long edge binding

Publicidad

Tabla de contenido
loading

Tabla de contenido