9000 731 350 A (Innenteil)
23
Figure
Wash the micro- and permanent filters.
The filter must then be left to dry for at least 24 hours.
After cleaning, place the permanent filter on the bottom
plate of the container.
Put the micro filter onto the container and fix it in place
by pushing in the direction of the arrow. You will hear the
flap snap shut.
Blockages
Removing a blockage in the dust container.
24
Figure
Empty the container (see figure 20)
Loosen the blockage, e.g. with a screwdriver, and tap or
vacuum it out.
(You must fit a dust bag in the vacuum cleaner before
vacuuming it out - see Figure 25)
Close the bottom flap so that it can be heard snapping
into position.
Caution: The micro- and permanent filters must be
!
cleaned following any operating problem (see Figure
22 and 23).
Using dust bags
If necessary, a dust bag may be used instead of the dust
collector.
25
Figure
Open the vacuum cleaner lid (see Figure 18)
Remove the dust collector and insert a dust bag.
Close the vacuum cleaner lid.
You have bought an extremely powerful device.
The highest suction setting is therefore only recommended
for heavily soiled, short-pile carpets and hard floors.
The required suction power can be selected by adjusting
the suction regulator (see Figure 9).
Low suction range:
For vacuuming delicate fabrics, e.g. curtains.
Middle suction range:
For daily vacuuming of lightly soiled floors.
High suction range:
For vacuuming durable floor coverings, hard floors and
for heavily soiled surfaces.
10
04.12.2011
10:30 Uhr
Replacing the dust bag
Figure
If suction diminishes considerably, the dust bag must be
replaced, even if it is not yet full. In this case it is
essential to change the dust bag due to the type of
material it contains.
Turn the dust compartment locking lever in the direction
of the arrow to open the vacuum cleaner lid.
Figure
Seal the dust bag by pulling the locking tab and then
remove it.
Figure
Place a new dust bag in the holder and close the vacuum
cleaner lid.
Caution: The dust bag compartment lid will only close
!
when the dust bag, textile filter or dust collector are
inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure
Open the dust bag compartment lid (see Figure 18).
Pull out the motor protection filter in the direction of the
arrow.
Clean the motor protection filter by tapping it.
If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the appliance.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
Do not use a scourer, glass-cleaning agent or
!
multipurpose cleaning product.
Never immerse the vacuum cleaner in water.
If necessary, the dust compartment can be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.
Seite 10
26
27
28
29*