Function Keys - Siemens SIMATIC HMI KTP700F Mobile HW Información Del Producto

Rear view and interfaces
①
USB port with cover
②
Handle
③
Rating plate
④
Terminal compartment
Operator controls and displays
Operating the handwheel
The handwheel can be turned without a stop and does not have a zero position. To facilitate operation, the handwheel has a
small recess.
Operating the override rotary switch
The override rotary switch has 19 positions. The zero and maximum positions are at the bottom.

Function keys

The function keys are shown in "Design of the KTP700F HW/OR (Page 16)". A function key can be assigned a global or a
local function.
● Function keys with global function assignment
A globally assigned function key always triggers the same action on the HMI device or in the controller regardless of the
screen displayed. Such an action could be, for example, the activation of a screen or the closure of an alarm window.
● Function keys with local function assignment
A function key with local function assignment is screen-specific and is therefore only effective within the active screen.
KTP700F Mobile HW, KTP700F Mobile HW/OR
A5E44033674-AA, 08/2018
⑤
Threaded sleeve for mounting screw of the cable retainer
⑥
Slot for an SD memory card
⑦
12-pin connector for the connecting cable
⑧
RJ45 socket PROFINET (LAN)
17