Fein MShyo869-1d Instrucciones De Uso página 16

OBJ_BUCH-0000000344-001.book Page 16 Tuesday, February 11, 2020 11:46 AM
en
16
Changing the tool (figure 4).
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
MSho852-1 (**)/MShyo852-3a (**)/4a (**):
Lock the output spindle at the inner flange
with the retaining pin.
MShyo869-1 (**): Lock the output spindle
with the hex key.
Loosen the threaded flange with the double-
pin wrench.
Unscrew the threaded flange.
Take care that the inner flange is mounted
firmly on the output spindle and that the cen-
tering sleeve is mounted.
Replace the used-up grinding accessory or
insert a new one.
Make sure to check that the grinding acces-
sory is wider than the height of the centering
sleeve.
Pay attention that the grinding accessory
is properly centered between the inner
flange and the threaded flange.
MShyo869-1 (**): Mount the outer flange
onto the threaded flange.
Manually screw on the threaded flange again.
MSho852-1 (**)/MShyo852-3a (**)/4a (**):
Hold the output spindle at the inner flange
with the retaining pin.
MShyo869-1 (**): Hold the output spindle
with the hex key.
Tighten the threaded flange with the double-
pin wrench.
Fig. 4
Face spanner
Allen key
Face spanner
MShyo869-1.. (**)
Locking pin