Controls; Switching On / Off; Adjusting The Height Of The Cutter; Changing The Cutter - Renfert Millo Manual De Instrucciones

2. Operation

2.1 Controls

Millo pro (Fig. 1, 2)
Millo (Fig. 3, 4, 5)
A ON / OFF button
B ON / OFF LED display
C Height adjustment (only Millo pro)
D Connector for extractor
E Plug-in socket for connecting an ex-
tractor (only Millo pro)
F Safety cut-out (Millo pro, Fig. 2)
G Fuse links (Millo, Fig. 5)
H Mains cable

2.2 Switching on / off

Switching on the unit:
• Press the ON/OFF button (A, Fig. 1 & 3):
- LED display lights up;
- cutter rotates.
- Only Millo pro:
Electricity is supplied to the plug-in
socket and the connected extractor,
which is already switched on, starts.
Switching off the unit:
• Press the ON / OFF button
(A, Fig. 1 & 3):
- LED display goes out;
- cutter comes to a stop.
- Only Millo pro:
The electricity supply to the plug-in
socket is switched off and the connect-
ed extractor comes to a stop.
2.3 Operating instructions
Sections of the dental arch may
break off during trimming.
Wear protective glasses!
The dust created during trim-
ming can be hazardous to
health.
Wear a face mask!
Risk of injury to hands!
The cutters of the trimmer are
sharp.
Risk of injury!
When working with the tapered
coarse cutter on plastic dental
arches risk of injury by hooking
into and flying around.
Use the tapered cross-cut cutter
for plastic dental arches.
Depending on the pressure ap-
plied, sound pressure levels of
over 85 db(A) can occur.
Wear ear protection!
Risk of injury by becoming en-
tangled in the unit!
Do not operate with unprotected
long hair or loose clothing.
• Control the dental arch on the work table
using both hands.
• Always keep hold of the dental arch
when it is in contact with the cutter.
• Move the dental arch counter to the
rotational direction of the cutter:
- optimal removal
- reduces the risk of the cutter catching.
2.4 Adjusting the height of the
cutter
Only the Millo pro (Fig. 11)
Raising the cutter:
• Turn the adjustment wheel to the left.
Lowering the cutter:
• Turn the adjustment wheel to the right.

2.5 Changing the cutter

Risk of injury!
The cutters are sharp. Take great
care when changing the cutters.
Risk of injury!
The cutters heat up during trim-
ming. Allow them to cool before
changing them.
Always use Renfert cutters.
- 3 - EN