Approved Personnel; Prior To Installation; Connecting The Extractor - Renfert Millo Manual De Instrucciones

The unit should always be oper-
ated under supervision.
The plug-in socket is only suit-
able for connecting an extractor.
The recommended connected
load should not be exceeded.
Risk of injury!
Risk of injury if the components
used are not approved.
Always use original Renfert
components.
Wear protective glasses!
Wear a face mask!
Depending on the work piece
involved, the operator's work
behavior (e.g., application pres-
sure), the setup location and
- in particular - the duration of
operation, the use of this device
can result in hearing damage.
The operator is obligated to have
the workplace related assess-
ment level checked in accord-
ance with local requirements
and to institute appropriate hear-
ing protection measures.
Wear appropriate personal pro-
tective equipment when working
with materials that are hazard-
ous to health.
Hazardous dust or fumes may be
created when trimming with the
unit. An extractor that is appro-
priate for the materials released
should be connected.
Switch off the unit when trim-
ming is complete.
Unplug the unit before carrying
out repairs or maintenance on
the electrical components.
EN
Switch off and unplug the unit
before cleaning or servicing it.
It is the responsibility of the op-
erator that national regulations
during operation and regarding
a repeated safety inspection of
electrical equipment are com-
plied with. For Germany these
are the regulation 3 by DGUV
(German Statutory Accident
Insurance) in relation with
VDE 0701-0702 (Association for
Electrical & Electronic Technol-
ogy).
Information on REACH and
SVHC is available on our website
www.renfert.com, in the Support
area.
C. Approved personnel
Operation and servicing of the Millo / Millo
pro dental arch trimmer should only be
carried out by trained personnel.
D. Prior to installation
Compare the data on the rating
plate with the data of the region-
al mains voltage before installa-
tion.
The unit should only be plugged
into earthed sockets.
D.1 Connecting the extractor
A corresponding connector (Figure 12)
is included in the standard delivery of
230 V units with outlets in accordance with
DIN 49441 (Figure 2, E). This connector
can be used to make an adapter for your
local plug configuration.
This adapter may only be made
by a qualified electrician!
The adapter must not interrupt
the ground circuit system!
- 8 -