Electrical Safety - BTI PROLINE PS 1800 Instrucciones De Manejo

w. Lock down button
x. Traverse bars
y. Saw head
z. Allen keys
aa. Cable clamp
bb. Cable
dd. Padlock hole
ee. Override button
ff. Carrying handle (left and right)
gg. Inner fl ange
OPTIONAL ACCESSORITES (FIG. 3–6, 25–27)
hh. Table end plate
ii. Support guide rails
jj. Material support plate
kk. Material clamp
ll. Swivelling stop
mm. Adjustable stand 760 mm (max. height)
nn. Legstand
oo. Length stop for short workpieces (to be used with
guide rails [ii])
pp. Roller table
qq. Dust extraction tubes
rr. Three-way connector

Electrical safety

The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the
voltage on the rating plate.
Your tool is double insulated in accordance with
EN 61029; therefore no earth wire is required.
In case of cord replacement the tool must only be repaired
by an authorized service agent or by qualifi ed electrician.
The following cords are mandatory:
PS1800: H07RN-F, 2x1.0 mm²
PS1800 LX: H05RR-F, 2x1.5 mm²
Mains plug replacement
(U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing
and you are competent to do this, proceed
as instructed below. If you are in doubt,
contact an authorized BTI repair agent or
a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely;
a plug with bared copper conductors is
dangerous if engaged in a live socket
outlet.
All manuals and user guides at all-guides.com
Fitting a mains plug to 115 V units
(U.K. and Ireland only)
•
•
•
•
Using an extension cable
If an extension cable is required, use an approved exten-
sion cable suitable for the power input of this tool (see
technical data).
The minimum conductor size is 1.5 mm². When using
a cable reel, always unwind the cable completely. Also
refer to the table below.
49
• Only fi t 13 Amperes BS1363A approved
plugs fi tted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to their
respective points in the plug (see below).
Brown is for Live (L) (2) and Blue is for
Neutral (N) (4).
• Before replacing the top cover of the mains
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable fi rmly
and that the two leads are correctly fi xed at
the terminal screws.
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N) wires
to the earth pin marked E or
The plug should be fi tted by a competent person. If
you are in doubt, contact an authorized BTI repair
agent or a qualifi ed electrician.
The wires are coloured according to the following
code:
live = brown
neutral = blue
Do not connect the blue or brown wire to the earth
terminal in the plug. Connect as follows:
brown to terminal marked 'L'
blue to terminal marked 'N'
The plug fi tted should be comply with BS EN 60309
(BS4343), 16 Amps, earthing contact position 4h.
WARNING: Always ensure that the cable clamp
is correctly and securely fi tted to the sheath of
the cable.
E N G L I S H
.