Manager; (X) 1- -7/8" Flat Head Screw; (T) Twist-Lock - Sauder 109872 Manual Del Usuario

7
Surface with
TWIST-LOCK R
FASTENERS
9/16" LARGE HEAD SCREW (BB)
(4 used for the CORD MANAGERS)
- Fasten the RIGHT UPRIGHT (C) and LEFT UPRIGHT (D) to the MODESTY PANEL (F) as shown. Tighten
two TWIST-LOCK
NOTE: Be sure the surface with TWIST-LOCK
shown. Follow the diagram.
- Fasten the RIGHT UPRIGHT (C) and LEFT UPRIGHT (D) to the SHELF (G). Use two 1- -7/8" FLAT HEAD
SCREWS (X) through each UPRIGHT and into the pre- -drilled holes in the ends of the SHELF.
- Now, fasten four CORD MANAGERS (S) to the MODESTY PANEL (F) as shown. Use a 9/16" LARGE HEAD
SCREW (BB) through each CORD MANAGER and into the pre- -drilled holes in the MODESTY PANEL.
NOTE: Be sure to position each CORD MANAGER as shown. Follow the enlarged diagram.
109872
RIGHT
UPRIGHT (C)
MODESTY
PANEL (F)
CORD
MANAGER (S)
R
FASTENERS in each UPRIGHT.
www.sauder.com/services
SHELF (G)
LEFT
UPRIGHT (D)
1- -7/8" FLAT HEAD SCREW (X)
(4 used in this step)
R
FASTENERS on the UPRIGHTS are facing out as
Use two 1- -7/8"
FLAT HEAD
SCREWS (X) here.
Surface with
TWIST-LOCK R
FASTENERS