Sauder 109872 Manual Del Usuario página 7

4
SHORT
MOLDING (K)
Finished
surface
9/16" LARGE HEAD SCREW (BB)
Follow the diagram at the top of the page closely for this step. Be sure the parts are positioned exactly as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the hole
of the adjoining part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Position the SHORT MOLDING (K) flat as shown in the top diagram with the finished surface facing up.
- Fasten the OUTER END (A) to the SHORT MOLDING (K) as shown in the top diagram. Tighten the
TWIST-LOCK R FASTENERS in the OUTER END.
NOTE: Be sure the unfinished surface of the OUTER END is facing as shown.
- Now, fasten a METAL BRACKET (U) to each LONG SKIRT (M) as shown in the bottom diagram. Use a 9/16"
LARGE HEAD SCREW (BB) through each BRACKET and into one pre- -drilled hole shown in each LONG SKIRT.
NOTE: Be sure to position the METAL BRACKETS as shown. The edge of each METAL BRACKET
should be even with the edge of the LONG SKIRT. Follow the bottom diagram.
OUTER
END (A)
Unfinished
surface
LONG
SKIRT (M)
(2 used in this step)
R
FASTENER (Refer to the enlarged diagram.)
www.sauder.com/services
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
LONG
SKIRT (M)
METAL
BRACKET (U)
109872