(O) Connector Plate - Sauder 109872 Manual Del Usuario

1
Read each step through completely before beginning the step. This box "-" is provided as a check- -off box. As you
complete each task, check it off.
NOTE: You must assemble the 109843 Executive Desk first, then the 109848 Return Kit before
assembling this unit (109872 U- -Shape Connector Kit).
NOTE: The diagram above shows the 109848 Return Kit attached to the right side of the 109843
Executive Desk. Your 109848 Return Kit may be attached to the left side of the 109843
Executive Desk or not at all yet.
- If the 109848 Return Kit is not yet attached to the 109843 Executive Desk, go to the next step now. If the 109848
Return Kit is already attached to the 109843 Executive Desk, continue with this step.
IMPORTANT: Have someone hold the 109848 Return Kit level while you are removing it from the
109843 Executive Desk.
- Remove the 109848 Return Kit from the 109843 Executive Desk. To do so, remove the four screws from each
connector plate that attach the plates to the Desk. Next, remove the support bracket from the Return Kit. To do so,
remove all six screws from the support bracket. And finally, remove the gold screws and washers that attach the
Return Kit modesty panel to the Desk.
NOTE: Save these screws and the support bracket. You will need them later in assembly.
109872
109843
Executive Desk
Remove three gold
screws and washers
from the modesty panel.
Also, completely remove
the support bracket from
both units.
www.sauder.com/services
Remove four screws
from this end of each
connector plate.
109848
Return Kit