Fastener - Sauder 109872 Manual Del Usuario

9
Do not insert
TWIST-LOCK R
FASTENERS into
these two holes in
the INNER END.
- Position the INNER END (B) as shown.
NOTE: Notice the location of the two holes in the middle of the INNER END.
- Push a SAUDER TWIST-LOCK
not push TWIST-LOCK
NOTE: Be sure the TWIST-LOCK
diagrams. Make sure the point is positioned as shown in the enlarged diagram. Do not
tighten the TWIST-LOCK
NOTE: If you need to remove a TWIST-LOCK
of the hole. Pull at the front and back edges, slowly working the FASTENER out of the hole.
109872
RETURN KITS ON RIGHT
Hole
R FASTENER (T) into the indicated large holes shown in the INNER END (B). Do
R FASTENERS into the other two large holes in the INNER END.
R FASTENERS are positioned exactly as shown in the enlarged
R
FASTENERS at this time.
www.sauder.com/services
Dowel end
INNER
END (B)
Hole
R FASTENER from a hole, pull the FASTENER back out
Make sure this point
is in this location.
R
TWIST-LOCK
FASTENER (T)