Sauder 109872 Manual Del Usuario página 42

24
Connector
Plates
109848
Return Kit
1- -1/2" FLAT HEAD SCREW
(3 used in this step)
- With someone's help, carefully position the 109848 Return Kit next to the 109872 U- -Shaped Connector Kit as shown
in the diagram.
- Fasten both connector plates (from the 109848 Return) to the bottom of the MOLDINGS on the Return Kit and
U- -Shape Connector Kit. Use eight 9/16" LARGE HEAD SCREWS (from the 109848 Return Kit) through each plate
and into the pre- -drilled holes in the MOLDINGS of both units.
NOTE: The Connector Plates may already be assembled to the 109848 Return Kit. If so, the
Connector Plates will each require only four 9/16" LARGE HEAD SCREWS.
- Now, fasten the modesty panel of the 109848 to the INNER END (B) on the U- -Shape Connector Kit. Use three
1- -1/2" FLAT HEAD SCREWS with WASHERS (from the 109848 Return Kit) through the holes in the modesty
panel and into the pre- -drilled holes in the INNER END on the Desk.
IMPORTANT:
indicated in this step.
109872
RETURN KITS ON LEFT
Fasten the modesty panel on the
109848 along this edge of the
INNER END (B) using the 1- -1/2"
FLAT HEAD SCREWS and
WASHERS you saved from step 1.
Modesty Panel
(from the 109848 Return Kit)
The 109848 Return Kit must be attached to the 109872 U- -Shape Connector Kit as
www.sauder.com/services
TOP (E)
WASHER
(3 used in this step)
109872
U- -Shape
Connector Kit
9/16" LARGE HEAD SCREW
(16 used for the PLATES)
(from the 109848 Return Kit)