(Y) 1- -1/2" Flat Head Screw - Sauder 109872 Manual Del Usuario

11
Use two 1- -7/8"
FLAT HEAD
SCREWS (X) here.
INNER
END (B)
- Fasten the MODESTY PANEL (F), RIGHT UPRIGHT (C), and LEFT UPRIGHT (D) to the TOP (E) as shown.
Tighten the TWIST-LOCK
NOTE: You should tighten a total of eight TWIST-LOCK
MODESTY PANEL will hang past the end of the TOP. Follow the diagram.
- Now, fasten the INNER END (B) to the MODESTY PANEL (F). Use two 1- -7/8" FLAT HEAD SCREWS (X)
through the INNER END and into the pre- -drilled holes in the edge of the MODESTY PANEL.
109872
RETURN KITS ON RIGHT
MODESTY
PANEL (F)
R
FASTENERS in the MODESTY PANEL and both UPRIGHTS.
www.sauder.com/services
LEFT
UPRIGHT (D)
TOP (E)
RIGHT
UPRIGHT (C)
1- -7/8" FLAT HEAD SCREW (X)
(2 used in this step)
R
FASTENERS in this step. The end of the
This end of the
MODESTY PANEL (F)
will hang past the end
of the TOP (E).