Coffee Maker - Beem MF3450-A Manual De Instrucciones

NOTE: If there is too little water the appliance switches off before the water
boils.
CAUTION: Do not fill the kettle (11) above the MAX level. Water may overflow
and the heating element could become damaged. If the kettle (11) is overfilled
there is the risk of boiling water spurting out.
3. Make sure that the lid (6) is closed properly before you switch on the kettle (11).
6. The water boils quickly, then the on/off switch automatically switches off and the
signal lamps in the fill level indicator go out.
7. Lift the kettle (11) from the base station (13) to pour the water.
NOTE: Make sure that the on/off switch can be moved without any problem and
that the lid (6) is closed properly. Otherwise the appliance will not switch off
automatically when the water boils.
Before you switch on the kettle (11) again, let it cool down for 15 to 20 seconds. To start
the boiling process again, push the on/off switch (8) back down again.
6.3

Coffee maker

Hints and tips:
To check the desired water quantity find the cup markings on the water tank (15) and
on the glass pot (18). The markings correspond with the fresh water quantity. The
amount of coffee produced later will be a little less because the coffee powder absorbs
water and water evaporates.
Always use non-fizzy, fresh, cold mineral or tap water. Never fill the water tank (15)
with milk, ready coffee, tea, sugar etc.
Never use hot water.
Thanks to the practical permanent filter (20) you do not need to use paper filters with
this appliance.
You will achieve the best tasting coffee with a clean coffee maker. Clean it regularly as
described in chapter 7.
Store unused coffee powder in a cool, dry place to preserve the flavour. Seal up an open
packet of coffee properly and put it in the refrigerator. This will keep the coffee fresh.
Do not reuse already used coffee powder a second time as this will give the coffee
greatly reduced flavour.
It is not recommended to reheat cold coffee because its taste can not be compared with
freshly made coffee.
BEEM – Elements of Lifestyle
4. Place the kettle (11) on the base station (13). Turn it so
that the spout points towards the protrusion (a) and the
kettle (11) locks in place in the catch (b).
5. Push the on/off switch (8) down. The red signal lamps
in the water level indicator (10) light up.
CAUTION: Hot steam escapes when water is boiling.
Do not open the lid (6) of the kettle (11) when water
is being boiled or immediately after it has boiled.
NOTE: You can stop the boiling process at any time
by pushing the on/off switch (8) up.
29 / 88