Use Accessories; Use With Joie Infant Child Restraint; Cleaning And Maintenance - Joie evalite duo Manual De Instrucciones

Ocultar thumbs Ver también para evalite duo:
Tabla de contenido

Publicidad

Use Accessories

Accessories may be sold separately or may not be available
depending on region.
Use Rain Cover
see images
50
To assemble the rain cover, place it over the stroller, then
attach it on the handle by hook and loop fasteners and wrap
the webbings on the rain cover around the mounts, and then
snap buttons.
50
!
When using the rain cover, please always check its
ventilation.
!
When not in use, please check that the rain cover has been
cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain
cover during hot weather.

Use with Joie Infant Child Restraint

see images
-
51
54
When using with Joie infant child restraint gemm, i-Gemm 2,
i-Snug, please refer to the following instructions.
!
Recline the stroller rear seat to the lowest position.
1. Make sure the infant child restraint lock is open on the right
stroller handle.
51
2. Place infant child restraint into rear seat of stroller so
notches in rockers fit over edge of armbar. Then click the
infant child restraint into place.
3. Lock the infant child restraint lock.
!
Pull up on the infant child restraint to check that it is fully
locked to the stroller.
21
52
53
4. To remove the infant child restraint, Open the infant child
restraint lock, squeeze the stroller release handle to release
the infant child restraint from armbar, and then lift infant
child restraint out of stroller.
!
If you have any problems using the infant child restraint,
please refer to the infant child restraint instruction manual.
!
Remove infant child restraint before folding.

Cleaning and Maintenance

see images
55
!
Removable seat pad may be washed in cold water and drip-
dried. No bleach. Please refer to the care label for instructions
on cleaning the fabric parts of the stroller.
!
To clean stroller frame, use only household soap and warm
water. No bleach or detergent. Periodically wipe clean plastic
parts with a soft damp cloth. Always dry the metal parts to
prevent the formation of rust if the stroller has come into
contact with water.
!
From time to time, check your stroller for loose screws, worn
parts, torn material or stitching. Replace or repair the parts as
needed.
!
Excessive exposure to sun or heat could cause fading or
warping of parts.
!
If stroller becomes wet, open hood and allow to dry
thoroughly before storing.
!
If wheels squeak, use a light oil (e.g. , Silicon Spray, antirust
oil, or sewing machine oil). It is important to get the oil into
the axle and wheel assembly.
!
When using your stroller at the beach or other sandy/dusty
environments, completely clean your stroller after use to
remove sand and salt from mechanisms and wheel
assemblies.
54
55
22

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido