Festo CPX-CEC-C1 Manual De Instrucciones página 19

Dismounting:
1. Undo the 4 screws of the CPX−CEC−C1.
2. Pull the CPX−CEC−C1 away from the contact rails of the
interlinking block carefully and without tilting.
Mounting:
Note
Mount the CPX−CEC−C1 in the left−hand end position of
the CPX terminal (position 0).
1. Check the seal and the sealing surfaces.
2. Place the CPX−CEC−C1 in the interlinking block. Make
sure that the grooves with the terminals for electrical
contact on the bottom of the CPX−CEC−C1 lie directly
above the contact rails.
3. Push the CPX−CEC−C1 as far as possible into the
interlinking block carefully and without tilting.
4. Place the screws so that the self−cutting threads can
be used.
5. Tighten the screws by hand in diagonally opposite
sequence. Tightening torque 0.9
Festo P.BE−K−CPX−CEC 0907NH English
1.1 Nm.
19