Agilent Technologies 969-9518 Manual De Instrucciones página 167

16
Instructions for Use
Preparation prior to Installation
During the unpacking procedure, be careful to avoid dropping the
controller of hitting it against anything. Do not discard the packaging
material in the environment. The packaging material is completely
recyclable and complies with the EEC environmental protection
directive 85/399. Before installing the controller you need to prepare
certain interconnection cables such as, for example, the power
supply interconnection cables, the logic interconnection cables and
the pump interconnection cable. The following figures provide the
connection diagrams between the controller and pump and between
the controller and power supply. For further information on these
interconnections and for the technical characteristics of the
transformer (available as option), refer to the Appendix entitled
"Technical Information".
Figure 2 Controller – Pump Interconection Cable
Turbo-V 70 PCB 24 Vdc Controller User Manual / 87-900-933-01 (H) 167/208