Maintenance; Error Messages - Agilent Technologies 969-9518 Manual De Instrucciones

17 Technical Information

Maintenance

Maintenance
Replacement controllers are available on an advance exchange basis
through Agilent. If necessary, information is provided to aid the
operator in determining malfunctions and corrective steps to be
taken.
Voltages developed in the unit are dangerous and may be fatal. Service must
WARNING!
be performed by authorized personnel only.

Error Messages

For a certain type of failure, the controller will self-diagnose the
error and the following messages will be displayed. The controller
signals the error occurred by means of a diagnostic LED located on
the board, and on the RS 232 port.
The LED blinks in a coded mode:
it flashes a number of time equal to the error code (see the following
table) and then stays off, and so on.
200/208 Turbo-V 70 PCB 24 Vdc Controller User Manual / 87-900-933-01 (H)