Maintenance Work; Replacing The Visor; Technical Data - Dräger X-plore 8000 Instrucciones De Uso

Transport
2. Clean all parts with the cleaning solution using a soft cloth. Make sure the
visor does not get scratched.
3. Thoroughly rinse all parts under running water.
4. Allow all parts to air-dry or dry them in the drying cabinet (temperature: max.
55 °C). Keep away from direct sunlight.
5.2

Maintenance work

5.2.1

Replacing the visor

Illustration on the fold-out page (figure D)
1. Remove face cuff and head cover.
2. Push out the fastening pins on the visor and remove the old polycarbonate
lens.
3. Insert the new polycarbonate visor and lock with the fastening pins.
4. Remount the head cover and the face cuff.
5.2.2 Replacing the sweatband
Illustration on the fold-out page (figure C)
1. Remove old sweatband from support ring.
2. Fasten a new sweatband on the hooks of the support ring.
5.2.3 Replacing the protective foil
1. If present, remove the old protective foil.
2. If necessary, wipe visor with a damp cloth and dry with a soft cloth.
3. Attach protective foil with the holes on the press studs on the visor.
6 Transport
Transport the product in its original packaging.
7 Storage
Store the protective visor dry and clean in the original packaging and protect it
from direct sunlight and thermal radiation.
8 Disposal
Dispose of the product in accordance with the applicable rules and regulations.
9

Technical data

Operating/storage temperature:
Operating/storage area humidity:
Material:
Visor:
Face cuff:
Visor bracket:
Protective foil:
Head cover:
Sweatband:
Head circumference of the support
ring:
Dräger X-plore
-5 °C to +55 °C
≤ 90 % relative humidity
PC
PA, PU-coated
PA, PU-coated
PET
PA
PA, foamed
51 cm to 64 cm
®
8000 Protective Visor