Beta 680/2,5 Instrucciones página 97

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
KEY TO SYMBOLS
a: digital display
b: unit of measurement
c: mode selection
d: hexagon male drive 27 mm
INSTALLATION DIAGRAM
INSTALLATION
Identify a suitable surface and position to install the instrument.
Mark the positions of the two mounting holes as shown in the installation diagram.
Drill (and tap, if need be) the two mounting holes (we recommend using a cheese-headed screw M10,
tester when the maximum permissible torque is applied.
The Dynatester is now ready for use.
OPERATION
Press and hold the MODE button to change the mode of operation. Release the button at the required
mode to accept.
MODES OF OPERATION:
• Track Mode (TRAC is displayed): the display reads the torque being applied.
data output of peak torque is automatically transmitted. The display automatically resets after
3 seconds. For use with click type torque wrenches.
• Dial Mode (DIAL is displayed): the display shows the peak of torque being applied. Press RESET
to clear the display. For use with analogue and electronic torque wrenches.
Press UNIT to change the unit of measurement.
EN I
-
9