Technical Data; General Warnings - Rupes LHR 15E Instrucciones Original De Uso Y Manutención

TECHNICAL DATA

PROTECTION CLASS
OPERATING VOLTAGE
ABSORBED CURRENT
ABSORBED POWER
ELECTRONIC SPEED CONTROL
ROTATION RPM
PAD FIXING THREAD
PAD DIAMETER mm
BUFFER PAD DIAMETER MAX mm
PAD TYPE
WEIGHT Kg

GENERAL WARNINGS

The safety and accident prevention instructions are reported in the "SAFETY
INSTRUCTION" booklet which forms an integral part of these documents; the
operating instructions indicate the additional information required specifically
for use of the tool.
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
This electrical tool is designed to be used as a grinder. Read all the warnings,
instructions, indications provided on drawings and specifications supplied
with this electrical tool.
Failure to comply with all the instructions provided below may cause electrical
shocks, fires and/or serious injuries.
This tool is not intended to be used for smoothing, metal brushing, polishing
and cutting operations.
The use of this tool for unintended applications may cause hazards and injuries to
people.
The tool must be used with accessories that have been specifically designed
or recommended by the manufacturer.
The fixing of the accessory to the tool does not guarantee a safe operation.
The rated speed of the accessory must be at least equivalent to the maximum
8
TYPE LHR15E
230 V - 50 Hz
4,3A
900W
YES
1500÷4000
M8
150
180
VELCRO FACED
1,850
speed specified on the electrical tool.
Using the accessories at speeds above the rated one may cause them to break or
be projected into the air.
The external diameter and thickness of the accessory must match the
specifications of the electrical tool.
Accessories with incorrect dimensions cannot be adequately protected or
controlled.
The configuration of grinding wheels, flanges, support pads or any other
accessory must match the electrical tool.
The use of accessories that cannot be perfectly fitted on the electrical tool may
result in imbalance, excessive vibrations and in the impossibility of controlling the
tool.
Do not use damaged accessories. Before use, inspect all the accessories.
Inspect the abrasive grinding wheels and verify that there are no splits or
cracks. Inspect the supporting pads and verify there are no cracks, tears or
excessive wear. Inspect the metal brushes and verify that there are no loose
or broken wires. If the electrical tool or accessory has fallen, verify that it is
not damaged or install a new accessory. After inspecting or installing an ac-
cessory, test the operation of the tool at maximum speed and without load for
one minute, keeping at a safety distance. If the accessories are damaged, they
will break during this test..
ENGLISH
LHR21E
II II
230 V - 50 Hz
5,3A
1100W
YES
2000÷4500
M8
150
180
VELCRO FACED
1,950
8