REMOTE CONTROL
Use the remote control transmitter to change the speed
●
of the fan and to switch the light and fan on or off.
Replace
●
compartment cover on the remote control transmitter in
the direction of the arrow,fit 2 x "AAA"batteries,ensure the
polarity of the batteries match with the figures shown in
the battery compartment.(Note: Batteries NOT included).
Re-assemble the battery compartment cover.
ALWAYS ensure the battery compartment cover is
●
closed properly.
DON"T expose the remote control to direct sunlight.
●
DON"T attempt to recharge expired batteries. There are
●
special rechargeable batteries, which are clearly marked
with.
DON'T dispose of batteries in fire to avoid explosion.
●
Note: Do make sure that the fan stops operating before
using the Direction Switch.
In order to prevent any damage to the motor or injury to
you, the switch should stay at the UP or DOWN position
when the fan is working.
20
the
batteries
Important
●
remote control
1. Please make sure the transmitter must
be used in the range of 800cm from the
infra red sensor.
2. Please make sure the transmitter
must be used in effective zone that is
330 degree from the center of infra red
sensor.
3. Please make sure the remote control
must comply with above two conditions
to work properly.
by
sliding
instructions
the
battery
for
using