Publicidad
Idiomas disponibles
Idiomas disponibles
16
This kit uses spring clamp style terminals.
Terminals use a steel spring to clamp the wire to provide improved
vibration resistance, reduced maintenance and faster installation.
To connect wires, firmly insert a slotted screwdriver into the square
hole (
) to open the spring. When fully inserted, the screwdriver will
1
lock into place, allowing you to remove your hand and insert the wire
into the round hole (
). Remove the screwdriver to clamp the wire.
2
The wire is held securely against the bus bar for low contact resistance
over time without the need to periodically retighten screws.
• Push screwdriver FIRMLY
into square hole.
• Insert wire into round hole.
• Use green terminal for braid
and ground wire.
JBS-100-A, A6 Installation Instructions
1
2
Wire
Screwdriver slot
Wire hole
• Remove screwdriver.
• Repeat for all connections.
7
Publicidad
