Operating Instructions; Monitoring Temperature(S) In Real Time - General DT61 Manual Del Usuario

OPERATING INSTRUCTIONS

MONITORING TEMPERATURE(S)
IN REAL TIME
To measure temperatures sensed by one or more
installed thermocouples, press the POWER button
to activate the thermometer. On the DT61, the
temperature sensed by the T1 thermocouple will
appear on the primary readout. On the DT62, the
temperature sensed by the T1 thermocouple will
appear on the primary readout and the T2
temperature (if a T2 thermocouple is installed) will
appear on the secondary readout. This is the
"normal" display mode for the DT62.
To swap the readouts on the DT62 (so T1 is shown
on the secondary readout and T2 is shown on the
primary readout), press the T1/T2/T1-T2 button.
To show the value of T1-T2 on the primary
readout and the value of T1 on the secondary
readout, press the T1/T2/T1-T2 button again. To
show T1-T2 on the primary readout and T2 on the
secondary readout, press the T1/T2/T1-T2 button
again.
When the DT62 is powered off and then on again, it
will resume operation in "normal" display mode—
with T1 on the primary readout and T2 on the
secondary readout.
To hold the value on the primary readout (DT61) or
the values on both readouts (DT62), press the HOLD
button. Note that while the thermometer is holding a
reading or readings, the relative time clock will
continue ticking. To release the hold and resume
real-time display of T1, T2 or T1-T2 values, press the
HOLD button again.
12