Setup Instructions; Install Battery; Perform Setup Procedure - General DT61 Manual Del Usuario

15. Relative time clock readout
16. min:sec. Relative time units
17. CAL. Flashes during calibration
18. INTERVAL. Not used on DT61 or DT62
19. hour:min. Relative time units
20. Type KJTERSN. Indicates selected thermocouple
type

SETUP INSTRUCTIONS

INSTALL BATTERY

To open the battery compartment, turn the
thermometer over and lift the flip-up stand (Fig. 1,
Callout 6) to gain access to the battery compartment
(Callout 7). Remove the single Philips-head screw
securing the battery compartment cover. Set the
cover and screw aside. Obtain a "9V" battery and
install it in the compartment observing the polarity
markings inside. Close the battery compartment by
replacing its cover and securing it with the screw.

PERFORM SETUP PROCEDURE

The setup procedures for the DT61 and DT62 are
identical, with one exception: Step 2—adjusting the
temperature compensation (offset) value—must be
performed twice, for the thermocouples of both
channels.
2. Set TC 3. Set APO
1. Set TC type
trigger
offset
7. Enter
Calibration
mode
6. Enable/
disable
5. Set power 4. Set relative
ambient
line
time clock
temperature
frequency
compensation
7