Sanus VMF220 Manual De Instrucciones página 8

2 Mount the Wall Plate
Wood stud mounting
2-1 Locate studs
2-2 Mark the wall
[03]
2-3 Drill pilot holes
2-4 Tighten lag bolts
[16]
[17]
8
≤ 16 mm
(5/8 in.)
[03]
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Verify the center of the stud using an awl. a thin nail, or an edge to
edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!

Drywall covering the wall must not exceed 16 mm (5/8 in.)

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.)
Level the wall plate [03] and mark the hole locations.
IMPORTANT: TV will shift 82.5 mm (3¼ in.)to the right when in the
home position. Consider this when selecting the location of your wall
mount.
Pilot holes MUST be drilled to a depth of 89 mm (3½ in.), using a 5½
mm (7/32 in.) diameter drill bit.
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage

DO NOT over-tighten the lag bolts [17].

Tighten the lag bolts only until the washers [16] are pulled
firmly against the wall plate [03].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
82.5 mm
3¼ in.
89 mm
(3½ in.)
6901-002023 07