Sanus VMF220 Manual De Instrucciones página 9

2 Mount the Wall Plate
Solid concrete or concrete block
2-1 Mark the wall
[03]
2-2 Drill pilot holes
2-3 Insert anchors and lag bolts
6901-002023 07
[24]
For assistance in determining wall plate location,
see Height Finder at sanus.com.
plate [03] and mark the hole locations.
property damage!



Level the wall plate [03] and mark the hole
locations.
82.5 mm
the right when in the home position. Consider this
3¼ in.
when selecting the location of your wall mount.
CAUTION:
Avoid potential injuries or property damage!

Pilot holes MUST be drilled to a depth of 89 mm (3½ in.) using a
10 mm (3/8 in.) diameter drill bit.

Never drill into the mortar between blocks.
89 mm
(3½ in.)
Insert lag bolt anchors [24]. Then insert lag bolts [17] through the
washer [16], wall plate [03], and into the anchors.
CAUTION:
Improper use could reduce the holding power of
the lag bolt. To avoid potential injuries or property damage:
[16]
[17]
13 mm
(1/2 in.)
CAUTION:
Avoid potential injuries or
Mount the wall plate [03] directly onto the
concrete surface.
Minimum solid concrete thickness: 203mm
(8 in.).
Minimum concrete block size: 203 x 203 x
406 mm (8 x 8 x 16 in.).
IMPORTANT: TV will shift 82.5 mm (3¼ in.) to
Be sure the anchors [24]
are seated flush with the
concrete surface.
Tighten the lag bolts [17]
only until the washers
[16] are pulled firmly
against the wall plate [03].
DO NOT over-tighten the lag
bolts [17].
[03]
10 mm
(3/8 in.)
Level the wall
9