Digital Display - Marshall MG101FX GOLD El Manual Del Propietario

FOOTCONTROLLER
STOMPWARE PEDL-90008 (OPTIONAL) CONT.
Pressing only the Store switch at this
point will overwrite the altered Channel or
Footswitch preset.
To store an altered Channel preset to the
Footswitch instead, hold the Store switch
and while held down, press your chosen
Footswitch (1) - just like a normal Preset
Store.
To store an altered Footswitch Preset to
another Footswitch hold the Store switch
and while held down, press your chosen
Footswitch (1) - Just like a normal Preset
Store.

DIGITAL DISPLAY

When recalling a footswitch preset, the
Digital Display (2) will indicate which
footswitch number has been pressed.
If a Channel preset has been recalled the
Digital Display (2) will remain blank.
When either a Channel preset or
Footswitch preset has been altered the
Digital Display (2) will begin to flash. The
footswitch will flash the relevant number
if a Footswitch preset has been altered or
will flash a "-" if a Channel preset has been
altered.
TUNER
The Tuner can be accessed in two ways:
By simultaneously pushing the Damping
(17) and Store (19) switches on the front
panel or by assigning the Tuner to the
footswitch. Note: On factory reset / first
switch on, the Tuner is already assigned to
Footswitch number 4.
Assigning the Tuner to a footswitch is
carried out like any other Switch Store.
To assign the Tuner to the footswitch
hold down the Damping (17) and Store
(19) switches and press the chosen
footswitch you wish to assign it to. The
Digital Display (2) will swirl to show that
the footswitch has been assigned. You
can then release the footswitch and front
panel switches.
FOR ALL AMPLIFIERS
When entering Tuner mode the unit
mutes and Clean/Crunch (3) and OD-1/
OD-2 (5) switches light yellow.
The Digital Display (2) indicates the
closest current note being played. The
indicator dot on the lower right hand
corner shows if the current closest note
♯
is .
The LED Status Panel (3) is used to show
how far away from the closest note the
current note being played is. When the
central FX Status LED lights, it indicates
the correct tuning, with the others
progressively indicating the tuning is up to
50 cents up or down.
To exit the Tuner push any footswitch,
the amplifier will then exit returning to the
settings before entering.
ENGLISH
NOTES
ENGLISH