Publicidad
Step 19
To insert a drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the unit
å
and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way in, then
it will slide in and out easier.
Insert the GROMMET (10P) and GROMMET CAP (1P) into the large hole in the TOP (C).
å
Insert the HALF GROMMET CAPS (64P) into the ENDS (A and B).
å
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. To clean your unit, dampen a cloth with tap water and wipe.
å
And to celebrate, why not share your success story?
1P
10P
64P
Page 24
40 lbs.
B
C
419606
64P
The drawer with the
DRAWER ACTUATOR
fastened to the lower set
of holes should be here.
A
45 lbs. each drawer
www.sauder.com/services
Publicidad
