Publicidad
Step 3
Step
Separate the EXTENSION SLIDES (J) from the EXTENSION RAILS (I) as shown in the upper diagram below. Be prepared,
å
the parts are greasy.
Fasten the EXTENSION RAILS (I) to the ENDS (A and B). Use eight BLACK 9/16" PAN HEAD SCREWS (51S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this
hole. You may need to apply some pressure on the SCREW with your Screwdriver to get it into the hole.
Push the black lever up and pull the SLIDE from the RAIL.
Use this hole.
I
Open end
This small hole
must be here.
Page 8
J
BLACK 9/16" PAN HEAD SCREW
(8 used in this step)
B
I
I
NOTE: Be sure to use the
correct screw in this step.
51S
I
A
419606
Open end
I
This small hole
must be here.
www.sauder.com/services
Publicidad
