Kit Preparation - Metra 95-3000 Instrucciones De Instalación

1. Remove the A/C vents from the factory
dash panel by releasing the spring
fastening clips securing them to the
panel. (Figure A)
2. Attach the vents to the 95-3000 radio
housing by inserting the inner edge of
the vent into the center inside pivot hole
and the outer edge of the vent into the
outer pivot hole. Use the same metal
spring clips from the factory dash panel
to secure the vents to the 95-3000
radio housing. (Figure B)
3. Place the cutting template over the
bottom edge of the radio opening.
Align the grooves in the template with
the factory clip locations in the dash.
Mark the area inside the template to be
cut and removed. (Figure C)

KIT PREPARATION

(Figure A)
(Figure B)
4. Remove the mounting screw from the
bottom left of the glove box door. Place
the clip mount in that location and
secure with the factory screw. (Figure D)
5. Remove (1) factory panel clip from the
factory dash panel and attach it to the
bottom left side of the 95-3000
radio housing.
6. Attach the (1) metal clip supplied to the
right side of the 95-3000 radio housing.
Continue to Kit Assembly
(Figure C)
(Figure D)
REV. 7/10/2017 INST95-3000
3