Kit Assembly - Metra 95-6523 Manual De Instrucciones

Double DIN radio provision
1. Attach the (4) panels clips to the
radio trim panel. (Figure A)
2. Break the small locating pin
from inside surface of each
radio bracket. (Figure B)
3. Position the radio mounting
brackets into the sub dash opening
and secure with the (2) Phillips
screws removed in disassembly.
(Figure C)
(Figure A)

Kit Assembly

Remove pin
(Figure B)
(Figure C)
95-6523
4. Attach the radio brackets to
the aftermarket radio using the
screws supplied with the radio or
the supplied (8) Phillips screws.
Note: Screws must not protrude
from slot in radio brackets as
interference with mounting
bracket will occur when sliding
radio into mounting brackets.
(Figure D)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS.
Re-connect the negative battery
terminal and test the unit for
proper operation.
6. Slide the aftermarket radio into the
radio opening between the radio
mounting brackets until it clips into
the opening. (Figure E)
7. Snap the radio trim panel into
the opening around the
aftermarket radio.
3
(Figure D)
(Figure E)