Guitar Tuner; Declaration Of Conformity; Factory Reset - Marshall CODE 50 El Manual Del Propietario

GUITAR TUNER

Pressing the PRE FX and AMP Section Switches (#15 & #16 in this manual) together
accesses the guitar TUNER:
• Pluck a string and the note you are playing will display.
• Tune the string until the name of the note you wish to tune to appears on the screen.
• The bar will move to the left if the note is flat. The bar will move to the right if the note is
sharp.
• When the bar is dead centre, that string is tuned to the displayed note.
• Press EXIT/STORE to exit the Tuner.

FACTORY RESET

Performing a factory reset will return CODE's Presets back to when it was new.
Before performing a factory reset, be sure that you want to overwrite all of your personal
!
Presets.
To perform a factory reset:
• Power OFF the amplifier using the ON/OFF switch (#14 in this manual).
• Whilst holding down the AMP Section Switch, turn the power ON.
• The screen will display a notification that the amplifier is about to be returned to its
factory settings.
• If you are sure that you want to perform a factory reset, press and hold the EXIT/STORE
switch to confirm.
• If you do not want to restore the factory presets, pressing any other switch will cancel the
factory reset operation and boot the amplifier as normal.
ENGLISH

DECLARATION OF CONFORMITY

Manufacturer:
A: >>|<< A: >>|<< A: >>|<< A: >>|<<
Kind of equipment:
Type designation:
We, Marshall Amplification Plc, declare under our sole responsibility that the above listed products complies with the following
Directives:
1. EMC Directive 2014/30/EU;
2. Low Voltage Directive (LVD) 2014/35/EU;
3. R&TTE Directive 1999/5/EC.
The following harmonised standards have been applied:
1. EMC
2. LVD
3. R&TTE
Signature:
Name of the responsible party:
Address of the responsible party:
Telephone number of the
responsible party:
Name of equipment:
Model No.:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Marshall Amplification Plc,
Denbigh Road,
Bletchley,
Milton Keynes,
Bucks,
United Kingdom
MK1 1DQ
Audio Equipment
CODE25, CODE50
• EN 55013:2013
• EN 55020:2007+A11:2011
• EN 61000-3-2:2014
• EN 61000-3-3:2013
• EN 60065:2014
Health &
• EN 62479:2010
Safety
• EN 60065:2002 + A1:2006 + A11:2008 + A2:2010 +A12:2011
(Article 3(1)(a))
EMC • ETSI EN 301 489-1 V1.9.2:2011
(Article 3(1)(b)) • ETSI EN 301 489-17 V2.2.1:2012
Spectrum
• ETSI EN 300 328 V1.9.1:2015
(Article 3(2))
Name: B. Moon
Jam Industries USA, LLC
1649 Barclay Blvd, Buffalo Grove, IL 60089, United States of America.
800-877-6863
MD116D Guitar Amplifiers
CODE25, CODE50
ENGLISH
Date: 2nd May 2016
16