Functional Description - Bosch 0 611 30A 0 Serie Manual Del Usuario

OBJ_BUCH-1144-001.book Page 15 Thursday, March 18, 2010 3:53 PM
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for heavy chiselling and
demolition work as well as for driving in and
compacting with the appropriate accessories.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Handle (insulated gripping surface)
3 Tool retainer
4 Tool holder
5 Tool shank
6 Shoulder
Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Bosch Power Tools
Technical Data
Demolition Hammer
Article number
Rated power input
Impact rate
Impact energy per stroke
according to EPTA-
Procedure 05/2009
Tool holder
Weight according
to EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in
case of unfavourable mains system conditions. Mal-
functions are not to be expected for system impedanc-
es below 0.36 ohm.
Noise/Vibration Information
Measured sound values determined according
to 2000/14/EC.
Typically the A-weighted noise levels of the
product are: Sound pressure level 93 dB(A);
sound power level 104 dB(A). Uncertainty
K=3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Chiselling: Vibration emission value a
2
Uncertainty K=1.5 m/s .
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
1 609 929 U79 | (18.3.10)
English | 15
GSH 27 VC
Professional
0 611 30A 0..
W 2000
-1
min 1000
J 66
mm 28
1
" 1 /
8
kg 29.5
/II
2
=8 m/s ,
h