Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Chargerready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1
Changingthetool
Secure the appliance against
switching on (see "Switch
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotatethekeylesschuck(1)towards
untilthedrillchuckapertureis
RELEASE
large enough to accommodate the tool.
2. Insertthetoolasfaraspossibleinto
thekeylesschuck(1).
3. Turnthekeylesschucktowards
ordertoclampthetool.
4. To remove the tool again, rotate the
keylesschuck(1)towards
thedrillchuckapertureislargeenough
to remove the tool.
Choiceofgear
Stopappliancebefore
changing gear.
1. Waitfortheappliancetocometoa
standstill.
2 Slidethegearselector(3)intothere-
quiredposition:
1: 0-400 min
-1
2: 0-1350 min
GRIP
RELEASE
-1
Set the direction of rotation
Theappliance'sdirectionofrotationcan
be changed with the rotational direction
switch.
The arrow on the direction switch indicates
theworkingdirection.
1. Waitfortheappliancetocometoa
standstill.
2. Pushtherotationaldirectionspeed
(7)intothedesiredposition:
To drill and screw in screws: Press the
directionswitchwiththearrowpoin-
ting forwards
To unscrew screws: Press the direction
switchwiththearrowpointingback-
wards
3. Ifyouplacethedirectionswitch
(7)inthemiddleposition,thedeviceis
secured against being switched on.
The direction change may only be
actuatedwhenatastandstill!
Torque adjustment
in
Youcanpreselectthemaximumtorque.
Thetorquesettingsarelabelled1-19+
until
1. Waitfortheappliancetocometoa
standstill.
2. Turnthetorqueadjustingring(2)to
select the desired torque:
Screws:
Drilling:
3. Start with a lower torquestepand
increase as required.
The direction change may only be
actuatedwhentheapplianceisata
standstill!
GB
Steps1-19
Step
IE
37