CAMPAGNOLO ERGOPOWER Manual De Usuario página 18

• Pass the cable through the RH slot on
the cable guide plate located underneath
the bottom bracket box (D - Fig. 9); insert
the cable through the pawl present on
the chain stay.
• Fit a casing end (some frames require the
use of the special casing end - F - Fig. 1
- Page 5) on the 330 mm - diameter ø 4.5 mm
casing, pass the cable through the cas-
ing and insert it in the pawl on the right
chain stay (A - Fig. 10).
Fit a casing end to the other end of the
casing and secure the cable to the rear
derailleur (refer to the rear derailleur
instruction manual for proper attachment
of the cable to the derailleur).
32
9
D
10
A
ENGLISH
Front derailleur cable and casing.
• Fit the end of the casing (330 mm long -
diameter ø 4.5 mm) with the casing end
already fitted in the external slot of the
LH Ergopower control unit (Fig. 4 - Pag. 12).
• Set the control at the smallest chainring
position by pressing lever (A - Fig. 11)
repeatedly and fit the front derailleur
cable (1,600 mm long - diameter ø 1.2 mm)
in the appropriate hole (B - Fig. 12).
• Cut the casing so that it reaches the dial
coupling on the frame (A - Fig. 13).
Be sure to leave enough slack in the cas-
ing to allow full handlebar movement.
Attach an end cap on the cut end of the
casing and attach the cable and the cas-
ing in the casing retainer clamp.
• Pass the cable through the LH slot on the
cable guide plate (B - Fig. 14) located
underneath the bottom bracket box and
secure the cable to the front derailleur
(refer to the derailleur instruction manual
for proper attachment of the cable to the
front derailleur).
13
ENGLISH
11
A
12
B
14
A
B
33