CAMPAGNOLO ERGOPOWER Manual De Usuario página 19

Rear brake cable and casing.
• Fit the brake cable (1,600 mm long -
diameter ø 1.6 mm) in the bushing on
the Ergopower control brake lever, mak-
ing sure that the cable stop head fits into
its seat (Fig. 15).
• 1998 range and later Ergopower con-
trols do not require a brake casing end.
• Depending on your frame, it may be nec-
essary to cut the rear brake casing
(1,250 mm long - diameter ø 5 mm) and
install a casing lead end (diameter ø 6 mm,
not supplied in your Ergopower package).
• Fit the casing (without the casing end) in
the brake casing retainer and secure the
cable to the brake (refer to the brake
instruction manual for proper attachment
of the cable to the brake).
Front brake cable and casing.
• Fit the brake cable (800 mm long - diameter ø 1.6 mm) in the bushing on the Ergopower
control brake lever, making sure that the cable stop head fits into its seat (Fig. 15).
• 1998 range and later Ergopower controls do not require a brake casing end.
• Fit the casing (580 mm long - diameter ø 5 mm) in the brake casing retainer (without the
casing end) and secure the cable to the brake (refer to the brake instruction manual for
proper attachment of the cable to the brake).
34
15
ENGLISH
Adjusting the cable tension.
• Rear derailleur cable tension can be
modified by turning the adjuster on the
provided Ergopower cable stopper (A -
Fig. 16) or by using the adjuster (B - Fig. 17)
placed on the rear derailleur body.
• Front derailleur cable tension can only
be modified with the adjuster on the
Ergopower cable stopper.
• Tape the handlebar, taking care to pass
the tape beneath the housing.
Be sure that you do not cover the groove
on the lower part of the body indicated in
Figure 18.
• Refit the support cover in position.
ENGLISH
16
A
17
B
18
35