Disposing Of Materials; Disposing Of Consumables; Packaging; Appendix - Abicor Binzel ABICOOLER 1300 Manual De Instrucciones

13 Appendix

12.1 Disposing of materials

This product is mainly made of metallic materials that can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labeled in preparation for their sorting and
separation for later recycling.

12.2 Disposing of consumables

Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
► Please observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the manufacturer of the consumables.
The disposal of dust collecting bags and disposal bags is subject to special waste regulations. The dust must
not enter sewage systems or be disposed of together with normal household waste.
► Observe the local and official regulations.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
13 Appendix

13.1 Connecting diagram for flow control

Fig. 6 Connecting diagram for flow control
Welding power source
Torch control switch on the
welding power source
EN - 22
Torch trigger
Connection housing
Connection for flow control
on the front of the device
Flow control
(low cooling liquid volume opens the circuit)
ABICOOLER 1300